Understanding Differential Reinforcement Strategies: DRL, DRH, and DRD in Behavior Analysis

Not every behavior needs to disappear. Sometimes a behavior is fine, it just happens too often, like a student who asks for help every two minutes. Other times a useful behavior happens too rarely. DRL, DRH, and DRD are differential reinforcement procedures that change how often a behavior occurs, instead of replacing it or eliminating it. This guide explains each one, the three forms of DRL, how to set criteria, and how to tell them apart on the BCBA exam.

Key takeaways

  • DRL (low rates) reinforces responding at or below a limit. Use it for behavior that is acceptable but too frequent.
  • DRH (high rates) reinforces responding at or above a minimum. Use it for behavior that is too slow or too rare.
  • DRD (diminishing rates) is a DRL with a limit that is lowered in steps. The term is used inconsistently, so check the definition.
  • DRL has three forms: full-session, interval, and spaced-responding.
  • DRL is not DRO: DRL allows some responding, while DRO reinforces zero responding.

What is differential reinforcement?

Differential reinforcement means reinforcing one response class (or one rate of responding) while withholding reinforcement for others. Most differential reinforcement procedures change which behavior happens: DRA reinforces an alternative behavior, DRI reinforces an incompatible behavior, and DRO reinforces the absence of the behavior.

DRL, DRH, and DRD are different. They target the rate of a behavior that is already in the learner’s repertoire. The behavior itself stays the same; what changes is how often it occurs.

On the BCBA exam, these procedures fall under Domain G, Behavior-Change Procedures (25 scored questions), task G.2 on differential reinforcement.

DRL, DRH, and DRD at a glance

DRL

Low rates

  • Goal: fewer responses, not zero
  • Reinforce: responding at or below a limit
  • Example: asking for help no more than 3 times per lesson

DRH

High rates

  • Goal: more responses
  • Reinforce: responding at or above a minimum
  • Example: completing 10 or more math problems in 15 minutes

DRD

Diminishing rates

  • Goal: gradually fewer responses
  • Reinforce: meeting a limit that is lowered in steps
  • Example: calling out 8, then 6, then 4 times per class

DRL: differential reinforcement of low rates

DRL reinforces a behavior only when it occurs at or below a set limit, or when enough time has passed since the last response. It lowers the rate of a behavior without eliminating it.

Use DRL when the behavior is appropriate in moderation but is a problem because of how often it occurs, for example: asking questions, requesting attention, raising a hand, eating too quickly, or checking in with a supervisor.

The three types of DRL

TypeHow reinforcement worksExample
Full-session DRLReinforce at the end of the session if the total number of responses was at or below the limitA student earns free time if she asks for help 3 or fewer times during a 45-minute lesson
Interval DRLDivide the session into intervals. Reinforce at the end of each interval if responses stayed at or below the limit for that intervalA token for each 10-minute block with no more than 1 call-out
Spaced-responding DRLReinforce a response only if a minimum amount of time (the interresponse time, or IRT) has passed since the previous responsePraise a bite of food only if at least 15 seconds have passed since the last bite
Full-session and interval DRL focus on how many responses occur. Spaced-responding DRL focuses on the time between responses.

A key difference: spaced-responding DRL reinforces the behavior itself, as long as it is spaced out, so it creates a positive link between responding and reinforcement. Full-session DRL withholds reinforcement if too many responses occur, which creates a negative link. In a 2014 laboratory comparison, Jessel and Borrero found that many participants stopped responding altogether under full-session DRL. If you want the behavior to continue at a lower rate, rather than stop, spaced-responding DRL may be the safer choice.

DRH: differential reinforcement of high rates

DRH reinforces a behavior only when it occurs at or above a set minimum within a time period. It is used to increase the rate of a behavior the learner can already do, but does too slowly or too rarely.

Common targets include work completion, reading fluency, social initiations, on-task responses, and exercise repetitions.

Setting a DRH criterion

  1. Measure baseline. Find the learner’s current rate across several sessions.
  2. Start close to baseline. Set the first criterion at or slightly above the average baseline rate, so the learner contacts reinforcement quickly.
  3. Raise it gradually. After the learner meets the criterion consistently, increase it in small steps.
  4. Stop at a socially valid goal. Decide in advance what rate is functional for the learner, such as the rate of typical peers.

If the criterion is set too high, the learner rarely earns reinforcement and the behavior is unlikely to change.

DRD: differential reinforcement of diminishing rates

DRD is most often described as a variation of DRL in which the limit is gradually lowered. Reinforcement is delivered when responding stays at or below the current criterion, and once the learner succeeds consistently, the criterion is reduced. Over time, the behavior steps down toward the final goal.

Watch the terminology. The term is not used consistently. Some sources use DRD for the spaced-responding form of DRL, where reinforcement follows a response only after a minimum amount of time has passed. Others use DRL as an umbrella term for both. On an exam, read the scenario carefully and focus on what is actually being reinforced.

DRH and DRD with a changing criterionLeft: under DRH, the criterion for reinforcement steps up from 3 to 6 to 9 responses per session and the behavior rises to meet each step. Right: under DRD, the criterion steps down from 10 to 7 to 4 responses and the behavior falls below each step.DRH: raise the criterion04812Sessions– – criterionDRD: lower the criterion04812Sessions– – criterionResponses
DRH and DRD both use a changing criterion: DRH raises it in steps to build a behavior up, and DRD lowers it in steps to bring a behavior down. Dashed lines show the criterion; dots show responses per session. (Illustrative data.)

Comparing DRL, DRH, and DRD

DRLDRHDRD
GoalLower rateHigher rateGradually lower rate
Reinforce when…Responses are at or below the limit, or spaced far enough apartResponses are at or above the minimumResponses are at or below a limit that keeps decreasing
Behavior remains?Yes, at a lower rateYes, at a higher rateYes, at a lower rate
Changing criterion?OptionalUsuallyYes, by definition
Classic exampleAsking for help 3 or fewer times per lessonAnswering 10+ problems in 15 minutesCall-outs reduced from 8 to 6 to 4 per class

DRL vs. DRO: a common exam trap

Both procedures reduce behavior, so they are easy to mix up. The difference is the goal:

  • DRL reinforces responding at or below an acceptable rate. Some responding is allowed, and expected. Use it for behavior that is appropriate in moderation.
  • DRO reinforces the absence of the behavior during an interval or at a specific moment. Any response resets or cancels reinforcement. Use it when the goal is zero, such as aggression or self-injury.

Quick test: if you would be happy for the behavior to keep happening a little, it is DRL. If the goal is zero, it is DRO.

How to set up a rate-based differential reinforcement program

  1. Define the behavior with a clear operational definition so every response is counted the same way.
  2. Measure baseline rate across several sessions, using the same session length you will use in treatment.
  3. Choose the procedure: DRL to decrease, DRH to increase, DRD to decrease in steps.
  4. Set the first criterion close to baseline so the learner succeeds early.
  5. Explain the rule when appropriate, for example with a visual tracker of how many responses are left.
  6. Deliver reinforcement consistently whenever the criterion is met.
  7. Adjust the criterion gradually, only after consistent success, until you reach the final goal. Then fade to natural reinforcement.

Common mistakes to avoid

  • Starting with a criterion that is too hard. If the learner rarely earns reinforcement, the procedure will not work.
  • Changing the criterion too fast. Move to the next step only after stable success at the current one.
  • Using DRL when the goal is zero. For dangerous behavior, use DRO or a function-based procedure instead.
  • Accidentally eliminating a useful behavior. Full-session DRL can push responding to zero. Monitor it, and consider spaced-responding DRL if the behavior should continue.
  • Ignoring function. Rate-based procedures work best alongside an understanding of why the behavior occurs.

Practice question

A teacher wants a student to keep asking for help when needed, but the student currently asks about 15 times per 30-minute lesson. The teacher gives the student a token at the end of each lesson if he asks for help 5 or fewer times. Which procedure is this?

  1. Differential reinforcement of other behavior (DRO)
  2. Full-session differential reinforcement of low rates (DRL)
  3. Spaced-responding DRL
  4. Differential reinforcement of high rates (DRH)
Show the answer

B. Full-session DRL. Reinforcement is delivered at the end of the whole lesson if the total number of requests stayed at or below the limit of 5. It is not DRO, because asking for help is still allowed. It is not spaced-responding DRL, because reinforcement does not depend on the time between requests. It is not DRH, because the goal is to lower the rate, not raise it.

Master Domain G, one task at a time

Behavior-Change Procedures is the largest domain on the BCBA exam. The free BCBA Study Checklist lists all 19 Domain G tasks so you can track exactly what you have mastered.

Differential reinforcement FAQ

What is DRL in ABA?

Differential reinforcement of low rates (DRL) is a procedure that reinforces a behavior only when it occurs at or below a set rate, or after a minimum amount of time since the last response. It is used for behaviors that are fine in moderation but happen too often, such as asking questions or raising a hand.

What is the difference between DRL and DRO?

DRL reduces a behavior to an acceptable, lower rate and still allows some responding. DRO reinforces the complete absence of a behavior during an interval. Use DRL when you want the behavior to continue at a lower rate, and DRO when the goal is zero.

What is DRH in ABA?

Differential reinforcement of high rates (DRH) reinforces a behavior only when it occurs at or above a set rate. It is used to increase behaviors that are in the repertoire but happen too slowly or too rarely, such as work completion or social initiations.

What is DRD in ABA?

Differential reinforcement of diminishing rates (DRD) is a variation of DRL in which the criterion for reinforcement is gradually lowered, so the behavior decreases in steps. The term is used inconsistently, and some sources use it for the spaced-responding form of DRL, so check how a question or textbook defines it.

What are the three types of DRL?

Full-session DRL (reinforce at the end of the session if responses stayed at or below the limit), interval DRL (the session is broken into intervals, and each interval at or below the limit earns reinforcement), and spaced-responding DRL (reinforce a response only if enough time has passed since the previous response).

Is DRL on the BCBA exam?

Yes. Differential reinforcement procedures fall under Domain G, Behavior-Change Procedures, of the BCBA Test Content Outline (6th ed.), which is the largest domain on the exam with 25 scored questions.

Related reading: Types of IOA in Various Data Collection Methods · Understanding Multiple Baseline Design · BCBA 6th Edition Task List Explained

About the author

Dr. Jaime Flowers, Ph.D., BCBA, is a Board Certified Behavior Analyst and the creator of ABA Study Guide, which helps BCBA candidates study one checklist item at a time. Read more about Jaime.

Last reviewed: November 20, 2026.

References

  • Austin, J. L., & Bevan, D. (2011). Using differential reinforcement of low rates to reduce children’s requests for teacher attention. Journal of Applied Behavior Analysis, 44(3), 451–461.
  • Behavior Analyst Certification Board. (2022). BCBA test content outline (6th ed.).
  • Cooper, J. O., Heron, T. E., & Heward, W. L. (2020). Applied behavior analysis (3rd ed.). Pearson.
  • Deitz, S. M. (1977). An analysis of programming DRL schedules in educational settings. Behaviour Research and Therapy, 15(1), 103–111.
  • Deitz, S. M., & Repp, A. C. (1973). Decreasing classroom misbehavior through the use of DRL schedules of reinforcement. Journal of Applied Behavior Analysis, 6(3), 457–463.
  • Jessel, J., & Borrero, J. C. (2014). A laboratory comparison of two variations of differential-reinforcement-of-low-rate procedures. Journal of Applied Behavior Analysis, 47(2), 314–324.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top